Open a STEP file
in Tinkercad.

Updated 2026-10-27

Tinkercad cannot open a STEP file. Its 3D import takes STL and OBJ under 25 MB. Convert the .step or .stp to STL below, then click Import in the editor. The conversion runs in your browser with nothing to install, and the STL comes into Tinkercad as one solid shape.

No account needed
Drop a STEP file.step / .stp · up to 200 MB

On our servers. No account: deleted within 24 hours. Signed in: kept until you delete them. Never shared or used for training.

TinkercadSTEP → STL

The 25 MB limit and assemblies

Most STEP files people bring to Tinkercad come from part libraries, such as a servo, a Raspberry Pi or a bearing. A single part converts to a small STL. A full assembly can be much bigger, because every curved face is meshed to 0.02 mm and a board with hundreds of components adds up. If the STL is over 25 MB, Tinkercad will refuse it. Convert only the part you need, or ask the source for a simplified model.

Whatever the STEP held comes in as one shape, and Tinkercad's help says an import cannot be ungrouped. That suits the most common use. Set the shape to Hole, group it with a box, and you have an enclosure or mount with a cut-out that matches the real part. Scale the hole up slightly if the part needs room to slide in.

The STL is in millimetres. Tinkercad shows scale settings after the upload and before the model loads, so keep millimetres.

Questions4 answered
Why is my converted STEP over 25 MB?
It is probably an assembly with many curved parts. Convert only the part you need, or use a simplified model.
Can I separate the parts after import?
No. Tinkercad turns the whole file into one shape that cannot be ungrouped.
Should I use STL or OBJ for Tinkercad?
Either imports. STL is the smaller file for the same shape, and most people use it.
Is the conversion free?
Yes. In the browser there is no daily limit. On our servers, 5 a day need no account.

Tinkercad's import formats were checked against its own documentation on 2026-10-27. The FAQ covers daily limits, file sizes and deletion.

MoreRelated

Tinkercad is a trademark of Autodesk, Inc.. MeshWeave is independent and not affiliated with or endorsed by Autodesk, Inc..